4 so it was half and half over the below layerīut if you set up. 4 (single layer) and S3d skipped 2 probably because there were not perfecly coinciding with a modular geometry based on. You can see example of what i am talking in this post i made long time ago
That number is really for S3D to decide what to insert in the code and what to skip it's not really representative of realty it's a number that s3d use to create the gcode model
as per their blurb 'New functionality in Simplif圓D will automatically adjust the amount of plastic that is extruded from the nozzle to create smaller or larger. which the main advantage is that you can get higher detail prints. Until I happened upon a post in Simplif圓D's forums I didn't understand the effects of changing the First. Such is the case with the First Layer Settings, under a process' Layer tab.
The layer thickness was fixed as the commonly used value. 39 in S3D as sometimes i make thiny detail 0.4 and S3D skip them if i use exactly 0.4 now that i use. I think what redbarret is wanting to talk about is the new feature in simplify 3d 4.0 called dynamic extrusion width. First Layer Height and Width: Simplif圓D 4.0 is a powerful 3D mesh slicer program for 3D printing with many options and settings, some of which are non-obvious. An illustration of raster angle and extrusion width from Simplif圓D toolpaths is shown in Figure 1. Plus if ur wall has some reveal in it you may want to add an extra layer to be able to hint reveal 0.4 in it 8 (2 layers) the thickens of a thick wall 1.2 (3 layer) and thickness of column or exterior bearing wall 2.4 (6 layers) Lots of strings and hairs left behind when. If you design the model urself is easier to design (especially architecture) based on. Printer does not extrude enough plastic, gaps between perimeters and infill.